Archive for category Craft Robo Tip

Paper Thickness of Silhouette and CraftRobo

Posted by Bimsan on Sunday, July 12, 2009

Quickutz has made an addition to paper thickness in gsm instead of lbs. You will find the Appendix here .

When you install and run it, you get the following box where you select GSM (UK)

install

Then you make two lists, one with no installed paper thicknesses and one of those installed. Here's how it looked at me.

start

And after I cleaned, I have these, then only paper I know - yay!

val-av-papper

Silhouette CraftRobo and use the same software, so even if the file is from Quikutz it works great with CraftRobo.

Paper thickness you already have will not go away!

Carrier Sheet

Posted by Bimsan on Friday, March 13, 2009

To make its own carrier sheet with the grid for the remnants.

Download Carrier Sheet (196)

You will need:

  • 2 A4 card stock (160-200 gsm)
  • A4 laminating pocket (and of course a laminator)
  • Xyron tape for Workstation with removable adhesive (removable adhesive spray or wide two-way Glue (Zig) works of course)
  • Removable tape

untitled-2.png

Check the following settings in RoboMaster:

File / Document Settings / Use Registration Marks to be bent
File / Output Setting / Print Cut Lines should be bent
Edit / Grid Settings / Grid Spacing shall be 10mm

This is consistent with it may want to check out.

  • Print page and you now have a copy of the screen, with grid, on paper.
  • Laminating a blank paper
  • Glue the printed sheet of what you are laminated
  • Tape the edges where the rollers will go with the removable tape
  • Run the whole package of Xyron or spaya with removable adhesive
  • Remove the removable tape
  • Dutta, eg kökshanduk one if it appears to the sticky

Voila, the world's best Carrier Sheet, where you can place small pieces of paper exactly.

Here's my out (accidentally put it upside down on nystämplat :) ) That would be done for istf inches. metrics.

carrier

Registration Mark

Posted by Bimsan on Wednesday, November 5, 2008

If you have problems with the registration marks attempt to add the paper further down on your carrier sheet. Normally, adds the paper flush with the top of the sticky part, but by putting it across the machine read labels better. The first line on the registration marking are visible between the knife and paper feed.

Registreringsmärke

Registration Mark

Settings knife

Posted by Bimsan on Wednesday, November 5, 2008
Media Type Cap Speed Thickness
130 gr Yellow 6 17
160 gr Yellow 5 25
Vinyl (from färghaneln) Yellow 6 8
Vinyl Metal (from färghaneln) Yellow 6 6 running two passport
Transparency Film (Inkjet) Yellow 4 17 running two-3pass *
Pärlpapper Yellow 6 11
Frisket Film Yellow 6 3
Thin (80-90 gr) Yellow 4 9
Labels (Inkjet) Yellow 6 15 A4

Values are given as a knife's sharpness and fitness affect the carrier sheet.
Always try to find settings that are yellow hat because I'm too lazy to change (though I know it can be improved with proper cutting knife)

* The reason I run so many times with light pressure is that I use it to airbrush stencils that are very small with a lot of details.